Laptop does not start. Fixing the problem.
If your laptop does not start at all or it starts but will not boot properly, it’s possible that you can fix the laptop at home without taking it to a repair center. Here are some troubleshooting tips for you. I’m not sure if I can cover all situation at once, so I will update this post as more examples come into my mind.
Situation 1.
The laptop appears to be dead. You plug the AC adapter but the LEDs (power light, hard drive light, battery charge light, etc…) do not light up and the laptop will not react at all if you press on the power button.
First of all in this situation check the AC adapter. You can test the output voltage with a voltmeter. If you cannot do that, find a known good AC adapter and use it for testing the laptop. It is possible the laptop appears to be dead because the AC adapter is bad (and the battery is discharged). If you know that the AC adapter is working properly and it outputs correct voltage but the laptop is still dead, most likely you have a power issue on the motherboard (or power board on some laptops) and it has to be replaced.
If you have to replace the AC adapter, make sure you use a correct one. The output voltage must be exactly the same as on the original adapter. The output amperage has to be the same as on the original adapter or higher, but not lower.
When you plug the AC adapter the power LED and the battery charge LED light up. When you press on the power button the laptop powers up but will not start. There is no video on LCD or external monitor.
If the power LED lights up it indicates that the laptop is getting power from the AC adapter. Most likely there is nothing wrong with the adapter but just in case test it with a voltmeter to make sure the output voltage is correct.
Also try this. Unplug the AC adapter, remove the battery and wait for 1-2 minutes. After that plug the AC adapter ans try starting the laptop again. Sometimes this trick helps.
It also could be a memory related problem. Try reseating the memory module, just remove it from the slot on the motherboard and install it back. Try installing the memory module into the other slot (if it’s available). If you have two memory modules installed, try removing them one by one and start the laptop just with one memory module installed.
If the laptop starts fine with one memory module in both slots, but will not start with the second memory module in both slots, the second memory module is faulty. Replace the module.
If the laptop starts fine with both memory modules when they are installed in the slot A, but will not start with both memory modules installed in the slot B, the slot B is faulty and you’ll have to replace the motherboard or use only one memory slot.
Situation 3.
When you press on the power button, the laptop makes a series or short and long beeps and will not start up. There is no video on the screen.
In this situation test the memory module as I described in the situation2. Try installing a known good memory module. Most likely you are getting a beep error because of a faulty memory.
Situation 4.
You start the laptop. It sounds like the laptop is booting normally (hard drive LED is flashing) but there is no video on the screen
In this situation test the laptop with an external monitor. If the external screen works fine but there is no video on the laptop LCD, most likely there is a problem inside the laptop display assembly. Go to my previous post witch covers laptop video problems in more details.
Situation 5.
You start the laptop and it starts making repetitive clicking noise or grinding noise.
Most likely you hear this noise because of a faulty hard drive. You can remove the hard drive and start the laptop without it. If the noise is gone, the hard drive is your problem. Replace it.
If the laptop makes clicking or grinding noises and you still have video on the screen, you can run a hard drive test utility. I usually use Hitachi’s drive fitness test. This test is reliable and easy to use.
Situation 6.
The laptop boots into Windows ans works for a while, but after that it shuts down by itself without any reason or warning. You restart the laptop but the same problem appears again
Most likely it’s a heat related issue. Listen for the cooling fan, make sure it works.
Also this problem might appear because of a faulty memory module, try some tips from the situation 2.
The laptop still boots ans you still can see the screen, so you can run the memory test. I usually use Memtest86+. Run the memory test and if it fails, replace the faulty module.
Situation 6
The laptop starts normally but video on the screen has lines, some strange characters or other defects
It could indicate a problem with the laptop LCD screen, video cable, graphics card or motherboard. Here’s my previous post witch covers troubleshooting bad images on the screen in more details.
Related post: How to troubleshoot dead laptops.
Entry Filed under: Laptop Tips and Tricks
190 Responses to “Laptop does not start. Fixing the problem.”
Pages: « 19 18 17 16 15 [14] 13 12 11 10 9 … 1 » Show All
Pages: « 19 18 17 16 15 [14] 13 12 11 10 9 … 1 » Show All
May 19th, 2008 at 1:23 pm
A Toshiba Satellite M55 does not start when I hit the power button. The left LCD at the front is on, which probably indicates that the power supply is working. Are there any known problems with this laptop? Sometimes, every now and then it starts up and works normal.
May 18th, 2008 at 9:24 pm
david wolff,
Can you tell where does the “click” sound come from? Does that sound come from the hard drive, from the DVD drive or from the motherboard?
Remove the hard drive and DVD drive and try turning it on again. Can you start the laptop now?
Maybe that sound comes from the cooling fan because it’s blocked by something? Check the fan.
May 18th, 2008 at 9:20 pm
pete,
I don’t think this is related to viruses, sounds like a hardware failure.
Clean the optical lens inside the drive with cotton swab and alcohol. Try again.
You can try reseating the DVD drive. Just remove it from the laptop and then install back. It’s possible the connection between the drive and motherboard is loose. Reseating the drive may help.
May 18th, 2008 at 9:15 pm
Luke,
Try to boot in Safe Mode and then use Windows System Restore utility. Restore it back to the time when the laptop was working fine, it might help.
If you still have the same problem, back up all personal file and reinstall Windows from the recovery disc.
May 16th, 2008 at 2:28 pm
Dell Insperon 6000
press the stert button, power light comes on,
then a click and it goes dead
tried pulling battery and using only AC power, same result.
Tried replacing battery, which is fully charged and disconecting AC power, same result.
A puzzlement?????
May 5th, 2008 at 6:35 am
I have a Toshiba M50, Had viruses which I cleaned out, now my DVD drive is not recognized in device manager, my computer and Bios. Dvd lights up but wont read disk so I Can’t reinstall windows.
Please help with suggestions.
Thanks
May 3rd, 2008 at 5:07 am
my laptop starts up all the way to the log on screen, when i log on it doesnt open my desktop. the screen goes black and it opens my documents. i scanned it for viruses but nothing has showed up. Please Help
April 29th, 2008 at 5:07 pm
Hi, I have a Toshiba Satellite Pro 6000 Laptop and I spilled Orange Juice all over the key board. I dried it off and have started to try and start it up again but when I press the power button nothing happens. There is the DC LED orange light that is blinking on and off. I have tried taking the battery out and plugging it into the outlet starting it that way but had no success. At one point the DC LED turned green and the battery LED turned orange but it would not start. Now it has gone back to the first orange blinking light. Can anybody help me?
April 26th, 2008 at 8:44 pm
Laura Shao,
The power button on IBM laptops is located on the keyboard. Maybe the power button is bad and the keyboard has to be replaced?
You can try reconnecting the keyboard first. Unplug it from the motherboard and then plug it back in. It’s possible the keyboard is not making good connecting with the motherboard and reconnecting the cable will fix your problem. Here’s service manual for ThinkPad T30, it explains how to disconnect and remove the keyboard.
If reconnecting or replacing the keyboard will not help, most likely you have a problem with the motherboard.
April 24th, 2008 at 5:11 am
I have a IBM T30 llaptop appears to be dead. When I plug the AC adapter, the Power Light LED light up, but the laptop could not react at all if I press on the power button.
Can you tell me what are the possible solutions?